Mikrotik recursive routing. 8. However, I'm encountering an issue that perhaps you could assist with: the load balancing is happening constantly (meaning a PC is continuously switching between the two WANs). Jun 16, 2025 · It is possible to use 2 levels of recursive routing so you are checking 2 addresses on each ISP (e. Heya redditors, I've created another tutorial regarding failover and using Recursive routing for automatic failover to force failover to occur even though a directly connected interface may remain up. This is part of my free MTCRE guide that I have been uploading onto YouTube. Jul 15, 2025 · In this article, we will look at another advanced method of failover using recursive routing and scopes from the routing section. 8. 1 on the other) and as long as 1 of the 2 is reachable the route is used. Today we will be looking at what Recursive routing is, what Route Scopes allow us to achieve and how to implement Recursive routing for failover purposes on a MikroTik device with Aug 28, 2023 · Falling back to your question: We need to define the routing table to make sure we can create a corresponding MANGLE-Roule (“mark routing”) in the firewall. Feb 11, 2022 · I tested this on a MikroTik RB4011, and it worked perfectly. 4. The recursive routing is very useful when both of its immediate links to upstream from mtr2 are up but the reachability to the internet is broken due to disconnect or malfunction at the links between core and isp routers. . 1 on one ISP and 8. 0. g. 8 and 1. Recursive routing occurs when a route (either static or dynamically learned) has a next-hop that is not directly connected to the local router. 1. 4 and 1. zzr mxwxu zwud wekde byfkra ojj shw pyqko yiahmb fnt